Table of Contents
Advertisement
Warning and Information Labels
Warning and Information Labels
The following labels appear on the air extraction system.
Preparation
Before installation, check the extraction system for damage. All packaging must be removed
before the system is connected to the power supply.
1. Move the system near the installation location and remove the outer packaging.
Labels
If the system is used in a manner that is not specified by the manufacturer, the system
warranty is void.
Important:
Read all instructions in this manual before using this system.
•
Intended use: This device is intended for indoor use only, to extract and filter
fume from a variety of 3D printers.
•
Install this system in a well-ventilated area.
•
If you intend to vent the air from the system directly into the room, place the
system at least 50 cm (19.5 in.) from another object on the side of the air outlet
to ensure adequate airflow.
Caution:
Do not cover the exhaust outlets, as this restricts the airflow and causes overheating.
© Copyright 2021 Stratasys. All rights reserved.
Meaning
Goggles, gloves, and masks must be
worn when handling used filters.
Electrical hazard. Removal of panels
with this label exposes electrical
components.
Warning. Turn the power to the system
off before opening the panel with this
label.
Location
Front of system.
Back of system
Near the cover
release clips.
Page 4
Advertisement
Table of Contents
