Nortel CallPilot 100 Quick Start Manual page 5

Mounting the CallPilot 100/150 on the wall
1
Attach the wall mount bracket to a secure surface by the two inner holes. Use anchors, as
necessary.
2 Slip the slot on the back (near the top) of the CallPilot 100/150 onto the bracket.
3
Secure the CallPilot 100/150 using a screw in the lower screw hole.
Note: If you are upgrading from a previous voice messaging system (for example,
FlashTalk) to CallPilot 100/150, you must remove the existing Feature Codes for the old
voice messaging system before you install the CallPilot 100/150. For information about
how to remove the existing Feature Codes, refer to CallPilot 150 Feature Codes are
inactive, in the CallPilot 100/150 Installation and Maintenance Guide.
Connecting the CallPilot 100/150
1
Open the CallPilot 100/150 by inserting a flat screwdriver into the slot on the right-hand side
of the door and pressing the tab out of the way.
2 Connect a TCM cable to Port A and to Port B.
Table 2 shows the pin out of Port A and Port B.
Table 2 Port A and Port B Pinouts
Pin number Port A
1
2
3
4
5
6
Note: On the CallPilot 100, only TCM 1 and TCM 2 are available for use.
Note: It is very important that you ensure that the Feature Cartridge is inserted into
the bottom PCMCIA slot before you power up the CallPilot unit.
3 Insert the feature cartridge into the bottom PCMCIA slot of the CallPilot 100/150.
4 Connect the other end of the TCM cables to station ports on your Norstar KSU.
Note: Do not connect the Ethernet cable for your LAN to the Ethernet port until you
initialize the CallPilot 100/150.
CallPilot 100
Port B
no connection no connection
no connection no connection
TCM 1 TCM 2
TCM 1 TCM 2
no connection no connection
no connection no connection
Installing the CallPilot 100/150
CallPilot 150
Port A Port B
no connection no connection
TCM 3 TCM 4
TCM 1 TCM 2
TCM 1 TCM 2
TCM 3 TCM 4
no connection no connection
CallPilot 100/150 Quick Start Guide
5