Nortel CallPilot 100 Quick Start Manual page 12

12 Initializing CallPilot 100/150 using a telephone
Table 3 Quick Install Wizard parameters for a CallPilot 100/150
Field name Description
Outdial Method Select the outdial method you want to assign to the mailboxes created using the From Extension
and To Extension boxes. You can choose None, Line, Pool or Route.
If you select None, no outdial method is assigned to the mailboxes.
If you select Line, click the Outdial Method text box and enter the line number of the line you want
assign to the mailboxes.
If you select Pool, click the Outdial Method text box and enter the line pool number of the line
pool you want to assign to the mailboxes.
Note: Line pool numbers 0 to 15 correspond to the Line Pools A to O on the KSU programming
interface.
If you select Route, click the Outdial Method text box and enter the route number of the route you
want to assign to the mailboxes.
4 Click the Install button.
You can now start programming the CallPilot parameters. For information about how to program
CallPilot, refer to the CallPilot Manager Set Up and Operation Guide.
Note: If you have changed any of the IP addresses or the Subnet Mask, you must reboot
the CallPilot 100/150 before you start programming the CallPilot 100/150 parameters.
Initializing CallPilot 100/150 using a telephone
To initialize CallPilot 100/150 you need to:
• determine the CallPilot 100/150 Feature Codes
• configure the CallPilot 100/150 initial parameters
N0008008 02