Advertisement
1.
Start by removing the finger guard
2.
Turn the hand-wheel
3.
Loosen the needle clamp
flat headed screwdriver, small pliers or a coin.
4.
Remove the needle
5.
Place the new needle
Push it gently as far up as it will go, and against the needle clamp (O).
6.
7.
Tighten the needle clamp screw
Replace the finger guard (Z).
8.
Note: Needles come in various sizes. The smaller the number, the thinner the needle. Use smaller
needles for more delicate fabrics and larger needles for heavier fabrics.
1
4
6
1.
The block at the front side of the sewing machine can be removed
in order to make sewing sleeves easier.
(Z)
by squeezing in the 2 sides and pulling it out towards you.
(K)
away from you to raise the needle
(O)
by turning the clamp screw toward you. You may need to use a small
(R)
by pulling it down, away from the needle clamp (O).
(R)
with the flat side facing in against the needle clamp (O).
(O)
while holding the needle
2
7
(R)
to its highest position.
(R)
in place.
3
5
Flat end
towards
clamp
8
replace
guard
9
Advertisement
