Advertisement
1.
IMPORTANT! Before inserting batteries or connecting to the mains, always make sure that both Auto
buttons
and
are in the o position (up position).
(A)
(L)
2.
If you are using batteries, insert x 4 AA batteries into the battery compartment
of the machine. Always use high power alkaline or rechargeable batteries.
3.
If you are connecting the machine to the mains power, plug the AC adaptor cable into the AC/DC
Jack
at the back of the machine. Then plug the AC adaptor into the wall mains.
(P)
4.
It is recommended that you remove all batteries before connecting the machine to the mains.
1.
The machine has two auto speeds of sewing control.
2.
Pressing down
3.
In this mode the machine will continuously stitch without the need for the foot pedal.
4.
De-pressing the button (button in up position) will return the machine to manual mode and the foot
pedal will be required to start stitching (recommended for beginners).
5.
Pressing down
De-pressing the button (button in up position) will return the machine to a lower speed
mode(recommended for beginners).
Manual /
Manua /l
Low Speed
1.
Make sure auto sew buttons are de-pressed.
2.
Plug the foot pedal jack
3.
Press gently on the foot pedal to begin stitching. Lift up to stop. When you are finished sewing a seam,
ease your foot up and o of the foot pedal to stop.
DC 6V
1000mA
FOOT PEDAL
DC 6V
button will put the machine into auto sew mode.
button will allow the machine to a sew at a higher speed.
High Speed
Low Speed
(M)
into back of machine.
1000mA
FOOT PEDAL
on
on the underside
(B)
Auto Sew Mode
Auto Sew Mode
o
Advertisement
