Advertisement
1.
Remove the finger guard
2.
Raise thread spindle
Place thread spool
(E)
3.
Pull thread from the thread spool
direction toward left side of machine.
Bring thread across to the second thread guide (2). Thread goes over the tension adjusting screw
4.
and must be positioned between the two washers behind the screw. Pull thread from tension adjusting
(Q)
screw
guide through thread guide
(5)
(D)
lever
inserting in the direction toward the left side of the machine.
5.
Pull thread down to thread guide
6.
Pull thread downward through thread guide (7). If necessary lower the needle
by turning the hand-wheel
lnsert thread through the hole
needle threader if necessary). If necessary raise the needle
(K)
slightly away from you.
7.
Raise the presser foot
8.
Pull about 12cm max of thread through the needle
running in the direction away from you. Lower the presser foot
Replace the finger guard (Z).
1
4
6
(Z)
by squeezing in the 2 sides and pulling it out towards you.
(C)
by pulling the exposed top upward until fully extended.
on the thread spindle
(E)
on the spindle
(4)
and toward take-up lever
(6)
and insert thread from the top downward.
(K)
slightly towards you to Iower the needle (R).
(8)
of the needle from the left toward the right side of the machine (Use
(F)
by lifting up on the lever at the rear of machine (G).
2
9 9
7
(C)
as shown.
(C)
and put through the thread holder
(R)
to reach the hole by turning the hand-wheel
(R)
and lay it on the deck under the presser foot (F),
(F)
by pulling the presser foot lever down (G).
3
5
9
8
(I)
(5)
(D). Pull thread through the take-up
(R)
to reach this thread guide
9
replace
guard
(1)
in the
(3)
(Q)
Advertisement
