Hoshizaki ROX-20TB2-EW Instruction Manual

Hoshizaki ROX-20TB2-EW Instruction Manual

Water electrolyzer
Hide thumbs Also See for ROX-20TB2-EW:

Advertisement

Quick Links

WATER ELECTROLYZER
ROX-20TB2-EW
INSTRUCTION MANUAL
FOR END USER
3-16 Minamiyakata, Sakae, Toyoake, Aichi 470-1194 Japan
L1X002114 (032017)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ROX-20TB2-EW and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hoshizaki ROX-20TB2-EW

  • Page 1 WATER ELECTROLYZER ROX-20TB2-EW INSTRUCTION MANUAL FOR END USER 3-16 Minamiyakata, Sakae, Toyoake, Aichi 470-1194 Japan L1X002114 (032017)
  • Page 2: [B] Control Panel

    In the context of this manual, the term "sanitizing water" refers to [1] Salt water tank acidic water and "cleaning water" refers to alkaline water. Stores salt water (5 liters). IMPORTANT [2] Water level sensor 1. This booklet is an integral and essential part of the product Senses the water level in the salt water tank.
  • Page 3: [C] Operation Panel

    [6] Flush button [1] Continuous dispense lamp (green) Functions as a switch to flush the pipes beyond the sanitizing and Lights in the continuous dispensing mode which is activated or cleaning water outlets. Also functions as down button to decrease the disactivated by pressing the dispense button or putting a hand or set values.
  • Page 4: Water Failure

    4. START UP [b] SUPPLYING SALT WATER CAUTION 1) Plug in the unit. Use sodium chloride (NaCl) or potassium chloride (KCl) of not less than 99% of purity. Use of any other salt may cause failure, 2) Open the water supply line shut-off valve. clogged pipes or health problems.
  • Page 5: Maintenance

    7. MAINTENANCE 6) When operating the unit in the pool mode, drain water from both water tanks. WARNING 7) To end the flush cycle, press the flush button again for 5 seconds 1. Do not splash water directly onto the unit. It may cause short with the dispense button off. The flush lamp goes off and circuit, electric shock, corrosion or failure.
  • Page 6 The attachment plug blades, their Clean. If the replace cell lamp is flashing, contact an authorized Hoshizaki vicinity, and receptacle are dusty. service company. The attachment plug is plugged into a Plug into a separate single receptacle with other equipment.
  • Page 7: Before Calling A Service Agent

    10) Open the water supply line drain valve. Hoshizaki’s liability under the terms of the warranty are limited and shall exclude routine servicing, cleaning, essential maintenance and/ or repairs occasioned by misuse and installations not in accordance 10.
  • Page 8 12. INSPECTION SHEET Make copies of this page. [a] DAILY INSPECTION SHEET Date Time Sanitizing water Cleaning water Neutralizer Available chlorine concentration* Salt water level Neutralizing agent level Water hardness Water leaks around unit Water leaks from water circuit Cell run time Checked by * Sanitizing water only Date...

Table of Contents