Steps - Nortel NN-10300-014 User Manual

Connect the IP Audio Conference Phone 2033 components

Steps

1. Connect one end of the CAT5 Ethernet cable to the network interface
located on the back of the Power over Ethernet (PoE) module. (see
Figure 5). Plug the other end of the CAT5 Ethernet cable in to the IP
network interface.
Figure 5: Power Over Ethernet (PoE)
2. Connect the CAT5 Ethernet cable attached to the PoE module to the
IP Phone. Thread the CAT5 Ethernet cable through the channel on
the bottom of the IP Phone and plug it into the PoE module port on
the IP Phone.
— If you are using local power, connect one end of the AC adapter
cord to the power supply port located on the back of the PoE
module. Thread the cord through the channel to the bottom of the
PoE module and plug the other end into the AC power source.
Ensure the correct AC power transformer is used. The voltage
rating on the transformer must match the wall outlet voltage.
24