Table of Contents
Advertisement
ASSEMBLY
4
Install the Drawer Runners
8
8
FRONT
8
D
Fully extend one Runner and align the inner section along the 3 small holes on the Left Divider. Verify that the
orientation of the Runner matches the diagram, then fasten the Runner to the Divider using 3 Screws
positioned as shown. Once the Runner is attached, slide it back to the closed position.
Attach the second Runner to the Right Divider
inserting Screws.
Insert Cam Bolts
1
Hardware Required:
5
Place Dowels
3
in the 2 innermost holes on either
side of the Bottom Shelf
Insert the Cam Bolts
Left Divider
into the corresponding holes in the
D
edge of the Bottom Shelf as shown. Secure by
inserting a Cam Nut
holes in the underside of the Bottom Shelf. Use a
Phillips-head screwdriver to turn the Cam Nuts
clockwise to secure the Cam Bolts.
Attach the Right Divider
using the same method.
Hardware Required:
7
on the Left and Right Dividers
8
7
7
1
Fully extend the runner to uncover
the mounting holes. After attaching
the runner to the panel, push runner
back into the closed position.
into the 2 indicated holes above the Runners on each Divider.
1
Cam Bolt x4
7
Runner x2
8
Screw (3x12mm) x6
K
.
1
previously installed in the
2
into each of the adjoining
E
to the Bottom Shelf
2
Cam Nut x4
3
Dowel x4
D
/
E
.
7
BACK
BACK
E
following the same method, checking orientation before
D
8
FRONT
1
8
E
7
E
K
3
2
8
8
8
3
2
6
Advertisement
Table of Contents
