Table of Contents
Advertisement
ASSEMBLY
1
Insert Cam Bolts
1
the Bottom Face Frame
screwdriver to tighten the threads into the
panels.
Hardware Required:
2
Insert Dowels
3
into the 2 remaining holes
in the Bottom Face Frame
Insert the hardware in the Bottom Face Frame
into the corresponding holes in the edge of the
Base Panel
as shown. Secure by inserting a
F
Cam Nut
into each of the adjoining holes in
2
the underside of the Base Panel. (HINT: the
small arrow on the flat side of the Cam Nut
should point toward the adjoining panel.)
Use a Phillips-head screwdriver to turn the
Cam Nuts clockwise to secure the Cam Bolts.
Hardware Required:
3
Install the Support Leg
Bottom Panel
F
using a Screw
Apply a Foot Pad
Support Leg. Press firmly to adhere.
Hardware Required:
into the 2 indicated holes in
. Use a Phillips-head
G
1
Cam Bolt x3
G
.
2
Cam Nut x3
3
Dowel x2
J
on the bottom of the
?
as shown.
?
to the bottom of the
?
Screw (5x40mm) x1
?
Foot Pad x1
G
ASSEMBLY NOTE: Use a Phillips-
head screwdriver to tighten each
Cam Bolt you install until its
threads are fully inserted.
G
3
→
F
1
2
3
F
→
2
J
5
Advertisement
Table of Contents
