Rear Lights (If Fitted); Roadworthyness - Hardi NL Series Instruction Book

NOTE: The shaft must always have a minimum overlap of 150 mm.
4. The two parts are shortened equally. Use a saw, and file the profiles
afterwards to remove burrs.
5. Grease the profiles and assemble male and female parts again.
6. Fit the shaft to tractor and
sprayer pump.
NOTE: Female part to-
wards tractor.
Fit the chains to prevent the
protection guards to rotate
with the shaft.
7. To ensure long life of the
transmission shaft, try to
avoid working angles larger
than 15°.
8. Transmission shafts with
cone must be fitted by
tightening the Allen screw
to a torque of 40 Nm.
Check again.

Rear lights (if fitted)

Connect plug for rear lights to tractors 7-poled socket and check that
rear lights, stop lights and turning indicators function properly.

Roadworthyness

When driving on public roads and other areas where the highway code
applies, or areas where there are special rules and regulations for
marking and lights on implements, you should observe these and
equip implements accordingly.
7