Table of Contents
Advertisement
7.8 Corrective maintenance
7.8.1 Deposits
Mild detergents and fine rubbing compounds reduce the weathering and calcium deposits accumulated
on the surfaces.
Do not apply the rubbing compound in direct sunlight.
NOTICE
•
Use only a fine grit compound, and follow the label instructions carefully.
•
For the best result, wax the surface after treating it with the rubbing compound.
7.8.2 Scratches and nicks
Most scratches and nicks can be removed by using a rubbing compound followed by waxing.
7.8.3 Stains
Most stains can be removed by washing with a mild detergent.
•
For stubborn stains, use a tine abrasive household cleanser followed by waxing to restore
original luster.
•
For non-water-soluble stains, such as grease, oil, and rubber heel marks, use a solvent such as
acetone, rubbing alcohol, toluene or xylene, followed by a mild detergent.
◦
If these solvents are not effective, try a rubbing compound or fine sanding followed by
waxing.
7.8.4 Deep marks, gouges and holes
Deep marks, gouges and holes should be repaired professionally.
Gelcoats can be well repaired by professionals, and in most cases the repair will be undetectable.
In cases where the damage has pierced the gelcoat layer, further exposure to
NOTICE
water or chemicals should be avoided.
Failure to observe this precaution may result in extensive and potentially costly
damage to the underlying laminate structure.
Brabus Shadow 500 Cabin 2020
Owner's Manual
© 2022 Axopar Boats / Brabus Marine
-
-
7 Maintenance
Document ID: 500CMY20202205EN
Page 63
Advertisement
Table of Contents
