Tritec SeaKing Profiling Sonar Product Manual page 23

Operation
5. Wait until the download has completed and until the table has been rebuilt.
The node status should change from Update to OK to indicate that the
download has been completed.
To Change a Node Number
Node ranges:
20 - 29 SeaKing DF Profiler
252
254
255
Changing node numbers is useful for running a Profiler application when 2
heads are connected that originally have the same node number (factory
supplied pairs should already be set up as master and slave). To reprogram a
node the Profiler heads to have the node number re-programmed should be
connected by itself and then follow the procedures outlined here to change
its node number.
!
1. Open Seanet Setup and wait for a few seconds for the nodes to build.
0374-SOM-00002, Issue: 04
Note
The different types of device are programmed with different ranges
of node numbers and these devices will not operate if a node value
is selected which is out of this range. For a full list of ranges for
different Tritech International Ltd devices please refer to the Seanet
Pro manual (document reference: 0706-SOM-00001).
SCUv5 or SeaHub
SKIM-100 Interface Box (obsolete)
ARCNET Interface Card (ISA or PCI AIFV4 card in a PC)
Caution
Only re-program nodes over short lengths of test cable (1m lengths
are available from Tritech International Ltd if not already supplied
with the sonar head at time of purchase). Longer cables increase
the risk of the data becoming corrupted in transit and could result
in the sonar head becoming unusable after the update.
23
SeaKing Profiling Sonar
© Tritech International Ltd.