Craftsman CMXEOCG232 Owner's Manual page 26

INSTALL THE SAFETY REVERSAL SYSTEM
(CONTINUED)
DOOR TRACK INSTALLATION
1. Slide the curved arms of the sensor bracket around the edge
of the door track. Snap into place so that the sensor bracket
is flush against the track.
2. Slide the hex screw through the sensor.
3. Attach the sensor to the bracket with the wing nut. Make sure
the lens is not obstructed by the bracket.
Repeat the steps with the other sensor on the opposite door track.
Both lenses must face each other.
WALL OPTION
Make sure the brackets on each side are clear of the door track and
have the same amount of clearance so the sensors will align
correctly. If additional clearance is needed, use extension brackets
041A5281-1 (not provided) or wood blocks.
1. Attach the sensor bracket against the wall with two lag
screws (not provided).
2. Slide the hex screw through the sensor.
3. Attach the sensor to the bracket with the wing nut. Make sure
the lens is not obstructed by the bracket.
Repeat the steps with the other sensor on the opposite side of the
garage door. Both lenses must face each other.
FLOOR OPTION
1. Measure the position of both sensor brackets so they will be
the same distance from the wall and unobstructed.
2. Attach the bracket to the floor with concrete anchors (not
provided).
3. Slide the hex screw through the sensor.
4. Attach the sensor to the bracket with the wing nut. Make sure
the lens is not obstructed by the bracket.
Repeat the steps with the other sensor on the opposite side of the
garage door. Both lenses must face each other.
Door Track Installation
Figure 1 Door track
Garage door
Figure 2
Figure 3
6" (15 cm) max.
HARDWARE
Hexagonal Screw 10-24 (2)
Wing Nut 1/4"-20 (2)
Wall Option
1
Inside
garage wall
Door track
Not provided
2 3
Floor Option
Inside
1 2
garage wall
Door track
3 4
Wing nut
OPTIONAL
OR
Wing Nut
6" (15 cm)
max.
Not
provided
Wingnut
6" (15 cm) max.