Table A-2 Component On The Rear Of The Cell - NEC A1160 Technical Overview

Table A-2 Component on the Rear of the Cell

Component
PCIe carrier/cards
Cell ID
Partition USB ports
Management serial port
Partition serial port
Maintenance LAN port
Partition video port
USB management port
Partition LAN ports
Navigation buttons
Figure A-1 Rear of the Cell
Description
Six hot-plug switched PCIe 8x card slots. Slots 1 and 4 can
support full-length cards. Each PCIe card is housed in an
individual carrier.
An LED that is lit when the ID button on the
EXPRESSSCOPE® Monitor is pressed. Press the cell ID
button on the rear of the cell to turn off the light.
Two universal serial bus (USB) 2.0 ports.
A 9-pin serial port for the management board.
A 9-pin serial port for the operating system.
An RJ45 port that provides a 10/100 Mbps Ethernet network
connection to the maintenance LAN.
A 15-pin SVGA port.
A USB 2.0 port for use with the management board.
Two RJ45 ports that provide 10/100/1000 Mbps Ethernet
network connections for the operating system. These ports
are typically connected to the public LAN.
Enables the selection of EXPRESSSCOPE® Monitor menu
options.
Components on the Rear of a Cell
A-3