Advertisement
Advertisement
Related Manuals for Nady Audio SPA 850
Summary of Contents for Nady Audio SPA 850
- Page 1 OWNER’S MANUAL XA SERIES STEREO POWER AMPLIFIERS...
-
Page 3: Table Of Contents
Congratulations on your choice of stereo power amplifiers — you have purchased one of the finest stereo amplifiers on the market to- day. This unit was developed using the expertise of professional sound engineers and working musicians. You will find that your new NADY AUDIO XA-900/1100 has superior performance and greater flexibility than any other amplifiers in its price range. -
Page 4: Warning
ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: Read all instructions before using the product. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, etc.). -
Page 5: Front & Rear Panel Connections
FRONT & REAR CONNECTIONS FRONT PANEL 1. POWER SWITCH To turn the unit ON or OFF, press the upper or lower portion of this button. Before turning on the amplifier, check all connections and turn down the level controls. A momentary muting is normal when turning the amplifier on or off. -
Page 6: Installation
(Note: Nady Systems is not responsible for shipping damage. If the unit is damaged, do not return to us, but notify your dealer and the shipping company immediately to make a claim. Such claims must be made by the consignee in a timely manner.) -
Page 7: Connections
2. The XA Series amplifiers maybe operated in one of three modes (stereo, bridged-mono, and parallel mono). Refer to the following wiring diagrams for the speaker connections you wish to make. (Note: Nady Systems assumes no liability for damaged speakers resulting from improper wiring, careless amplifier use, or over powering.) •... - Page 8 • Parallel (Mono) Mode To put the amplifier in parallel-mono mode, first turn the amplifier off, then slide the MODE SELECTOR SWITCH (13) to the middle “PARALLEL (MONO)” position and properly connect the input wiring as shown. A signal into any input jack will drive both channels directly.
-
Page 9: Block Diagram
BLOCK DIAGRAM... -
Page 10: Specifications
POWER SPECIFICATIONS EIA OUT POWER 1HZ, THD MAXIMUM 1% BOTH CHANNELS ELECTRICAL SPECIFICATIONS INPUT SENSITIVITY INPUT IMPENDANCE FREQUENCY RESPONSE (at 10dB below rated output power) VOLTAGE GAIN DISTORTION (SMPTE-1M) S/N RATIO GENERAL SPECIFICATIONS PROTECTIONS CONTROLS INDICATORS CONNECTORS POWER SUPPLY FUSES DIMENSIONS WEIGHT The specifications above are correct at the time of printing of this manual. - Page 12 DO NOT ATTEMPT TO SERVICE THIS UNIT YOURSELF AS IT CAN BE DANGEROUS AND WILL ALSO VOID THE WARRANTY. NADY SYSTEMS, INC. • 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608 Tel: 510.652.2411 • Fax: 510.652.5075 • www.nady.com...
Need help?
Do you have a question about the SPA 850 and is the answer not in the manual?
Questions and answers