Nady Audio XA-300 Owner's Manual

Nady Audio XA-300 Owner's Manual

Nady systems owner's manual stereo power amplifiers xa-300

Advertisement

OWNER'S MANUAL
XA-300
STEREO POWER AMPLIFIERS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XA-300 and is the answer not in the manual?

Questions and answers

Summary of Contents for Nady Audio XA-300

  • Page 1 OWNER’S MANUAL XA-300 STEREO POWER AMPLIFIERS...
  • Page 3: Table Of Contents

    Congratulations on your choice of the NADY AUDIO XA-300 stereo power amplifier — you have purchased one of the finest stereo amplifiers on the market today. This unit was developed using the expertise of professional sound engineers and working musicians.
  • Page 4: Warning

    ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: Read all instructions before using the product. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, etc.).
  • Page 5: Front Panel

    FRONT & REAR CONNECTIONS FRONT PANEL 1. POWER SWITCH To turn the unit ON or OFF, press the upper or lower portion of this button. Before turning on the amplifier, check all connections and turn down the level controls. A momentary muting is normal when turning the amplifier on or off.
  • Page 6: Installation

    Y-cord. In this mode the inputs for both channels are To ensure years of enjoyment from your NADY AUDIO XA-300 amplifier, please read and understand this manual thoroughly before using the unit.
  • Page 7: Connections

    1. Turn off the amplifier power switch before making any connections. 2. The XA-300 amplifier maybe operated in one of three modes (stereo, bridged-mono, and parallel mono). Refer to the following wiring diagrams for the speaker connections you wish to make.
  • Page 8 • Parallel (Mono) Mode To put the amplifier in parallel-mono mode, first turn the amplifier off, then slide the MODE SELECTOR SWITCH (12) to the bottom “PARALLEL (MONO)” position and properly connect the input wiring as shown. A signal into any input jack will drive both channels directly.
  • Page 9: Block Diagram

    BLOCK DIAGRAM...
  • Page 10: Power Specifications

    POWER SPECIFICATIONS OUTPUT POWER ... 120W RMS @ 8Ω per side (EIA 1KHz 1% THD) ELECTRICAL SPECIFIACTIONS INPUT SENSITIVITY ..500V RMS (-4dBu) INPUT IMPENDANCE ... 50KΩ Unbalanced & Balanced FREQUENCY RESPONSE (at 10dB below rated output power) ... 20Hz~20KHz ±1dB DISTORTION (SMPTE-1M) ...
  • Page 12 DO NOT ATTEMPT TO SERVICE THIS UNIT YOURSELF AS IT CAN BE DANGEROUS AND WILL ALSO VOID THE WARRANTY. NADY SYSTEMS, INC. • 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608 Tel: 510.652.2411 • Fax: 510.652.5075 • www.nady.com...

Table of Contents