Water Softener Filter; Installing The Ilter; Replacing The Ilter - DeLonghi PrimaDonna Elite ECAM65.75 Series Instructions For Use Manual

3. To change the level selected, press the symbol itself until
the required level is displayed (Level 1 = soft water; Level 4
= very hard water);
4. Press " ESC" to go back to the homepage.
The machine is now reprogrammed with the new water hard-
ness setting.
19.

WATER SOFTENER FILTER

Certain models are itted with a water softener ilter (C4). If this
is not the case with your model, you are recommended to pur-
chase one from De'Longhi Customer Services.
To use the ilter correctly, follow the instructions below.

19.1 Installing the ilter

1. Remove the ilter (C4) from the packaging;
"
2. Press " (B2) to enter the menu;
3. Press <(B10) or > (B8) until " WATER FILTER" appears on
the display;
4. Press " ";
49
the ilter installed, it will last a maximum of three weeks.
6. "RUN WATER INTO FILTER
50
5. "TURN THE DATE INDICA-
TOR UNTIL THE NEXT 2
MONTHS ARE DISPLAYED"
(ig. 49): turn the date
disk to display the next
2 months of use. Press "
NEXT";
Please note
The ilter lasts about two
months if the appliance is
used normally. If the cofee
machine is left unused with
HOLE UNTIL IT COMES
OUT FROM OPENINGS"
(ig. 50): To activate
the ilter, run tap water
through the hole in the
ilter as shown in the
igure until water comes
out of the openings at the
side for more than a min-
ute. Press " NEXT";
23
7. Extract the tank (A16) from the appliance and ill with
water.
8. "IMMERSE FILTER IN THE
5 5 5 51
9. "INSERT FILTER INTO ITS HOUSING AND PUSH IT DOWN TO
THE BOTTOM": Insert the ilter in the ilter housing (A17)
(ig. 48) and press as far as it will go. Press "
10. "INSERT WATER TANK": Close the tank with the lid (A15),
then replace the tank in the machine.
11. "PLACE 0.5l CONTAINER UNDER SPOUTS, PRESS OK TO FILL
FILTER" (ig. 8): Place the container under the hot water
spout (C6) and press " OK". Delivery begins and stops
automatically.
The ilter is now active and you can use the cofee machine.

19.2 Replacing the ilter

Replace the ilter (C4) when "REPLACE WATER SOFTENER FIL-
TER, PRESS OK TO START " appears on the display (B). To
replace the ilter immediately, press "
instructions from point 4.
To replace the ilter later, press "
appears on the display to remind you that the ilter needs
replacing.
To replace the ilter, proceed as follows:
1. Extract the tank (A16) and exhausted ilter;
2. Remove the new ilter from the packaging;
"
3. Press " (B2) to enter the menu;
4. Press <(B10) or > (B8) until " WATER FILTER" appears on
the display;
5. Press " ";
6. " REPLACE FILTER" appears on the display;
7. Press " ";
8. Follow the operations described in the previous section
from point 5.
The ilter is now active and you can use the cofee machine.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the ilter even if
the message has not yet been displayed.
WATER TANK LETTING AIR
BUBBLES ESCAPE" (ig.
51): Insert the ilter in the
water tank and immerse
it completely for about
ten seconds, sloping it
and pressing it lightly to
enable the air bubbles
to escape. Press "
NEXT";
NEXT";
OK" and follow the
ESC". The symbol