Yamaha YZF-R125 Owner's Manual page 20

Instrument and control functions
2. Push the "SELECT" button for two
seconds, and the hour digits will
start flashing.
3. Use the "RESET" button to set the
hours.
4. Push the "SELECT" button, and
the minute digits will start flashing.
5. Use the "RESET" button to set the
minutes.
6. Push the "SELECT" button to con-
3
firm settings and start the clock.
TIP
When setting the hours and minutes, a
brief push of the "RESET" button in-
creases the increment value one by
one. You may also push and hold the
button to increase the value continu-
ously.
Fuel meter
Hi
x1000r/min
Lo
km/h
4
ZAUM1303
1. Fuel meter
2. Fuel level warning light "
3. Fuel reserve tripmeter
4. Information display
The fuel meter indicates the amount of
fuel in the fuel tank. The display seg-
ments of the fuel meter disappear from
"F" (full) towards "E" (empty) as the fuel
level decreases. When the fuel level
becomes low, the last segment will
flash and the fuel level warning
light " " will come on ("LOW FUEL"
message will also appear). Refuel as
soon as possible.
TIP
If a problem is detected in the fuel me-
ter electrical circuit, all display seg-
ments of the fuel meter will flash eight
times, then go off for 3 seconds, re-
peatedly. If this occurs, have your
Yamaha dealer check the vehicle.
Coolant temperature meter
1 2
1. Coolant temperature warning indicator "
2. Information display
3. Coolant temperature meter
1/2
The coolant temperature meter indi-
FTRIP
cates the temperature of the coolant,
and therefore the engine. When the
coolant temperature is at its upper lim-
3
it, the second segment from the top
will start to flash. Should this occur, re-
"
duce the load on the engine by riding at
a moderate pace, at low rpm, until the
coolant temperature goes down. If the
top two segments and "
ing ("HIGH TEMP" message will also
appear), stop the vehicle and let the
engine cool.
3-6
3
2
ZAUM1304
Hi
1
Lo
"
" start flash-