Yamaha YZF-R125 Owner's Manual page 17

The electrical circuit of the warning
light can be checked according to the
following procedure.
1. Turn the key to "ON".
2. If the warning light does not come
on, have a Yamaha dealer check
the electrical circuit.
Engine trouble warning light "
This warning light comes on if a prob-
lem is detected in the electrical circuit
monitoring the engine. If this occurs,
have a Yamaha dealer check the vehi-
cle.
The electrical circuit of the warning
light can be checked by turning the key
to "ON". The warning light should
come on for a few seconds, and then
go off.
If the warning light does not come on
initially when the key is turned to "ON",
or if the warning light remains on, have
a Yamaha dealer check the electrical
circuit.
ABS warning light "
In normal operation, the ABS warning
light comes on when the key is turned
to "ON", and goes off after traveling at
a speed of 10 km/h (6 mi/h) or higher.
If the ABS warning light:
 does not come on when the key is
turned to "ON"
 comes on or flashes while riding
 does not go off after traveling at a
speed of 10 km/h (6 mi/h) or high-
er
Instrument and control functions
EAU11486
"
EAU69890
"
ABS
3-3
The ABS may not work correctly. If any
of the above occurs, have a Yamaha
dealer check the system as soon as
possible. (See page 3-15 for an expla-
nation of the ABS.)
WARNING
If the ABS warning light does not go
off after traveling at a speed of 10
km/h (6 mi/h) or higher, or if the
warning light comes on or flashes
while riding, the brake system re-
verts to conventional braking. If ei-
ther of the above occurs, or if the
warning light does not come on at
all, use extra caution to avoid possi-
ble wheel lock during emergency
braking. Have a Yamaha dealer
check the brake system and electri-
cal circuits as soon as possible.
Tachometer high-rpm warning light
This light flashes at 9500 r/min to warn
you that the engine speed is about to
enter the high-rpm zone. Once the en-
gine speed reaches 10000 r/min, this
light will come on to warn you that it is
necessary to shift up to avoid engine
damage.
To activate or deactivate the tachome-
ter high-rpm warning light, hold the
"INFO" button pushed, turn the key to
"ON", and when the tachometer high-
rpm warning light starts flashing, press
the "SELECT" button.
TIP
When activating or deactivating the
warning light the function, after press-
ing the "SELECT" button, the light will
EWA16041
3
EAUM3440