Table of Contents
Advertisement
Handle LED Adjustment
NOTE: The LED should turn ON as the handle is rotated open, and OFF when the
handle is in the upright (closed) position. Use a 5/64 " hex wrench to adjust the valve
setscrew as needed.
IMPORTANT! Do not apply upward pressure to the valve setscrew while making
adjustments.
LED is ON when the handle is closed: Tighten the valve setscrew until the LED
turns OFF. Then tighten the setscrew an additional 1/4 turn.
Handle does not return to the upright position: Loosen the valve setscrew until
the handle rotates to the full upright (closed) position and the LED turns ON.
Then tighten the setscrew until the LED turns OFF, plus an additional 1/4 turn.
Water does not fully shut off: Loosen the valve setscrew until the handle rotates
to the full upright (closed) position and the LED turns ON. Then tighten the
setscrew until the LED turns OFF, plus an additional 1/4 turn.
手柄LED灯调节
注意：手柄旋转开启时LED灯应点亮，当手柄在垂直（关闭）位置时，LED
灯应熄灭。按需使用5/64"六角扳手调节阀门的定位螺丝。
重要事项！调节时，请勿对阀门定位螺丝施加向上压力。
当手柄关闭时LED灯点亮：旋紧阀门定位螺丝直至LED灯熄灭，然后再旋
紧定位螺丝1/4圈。
手柄未返回至垂直位置：旋松阀门定位螺丝直至手柄旋转成垂直（关闭）
位置且LED灯点亮。然后旋紧定位螺丝直至LED灯熄灭，再额外旋紧1/4
圈。
水未能完全关闭：松开阀门定位螺丝直至手柄旋转到垂直（关闭）位置且
LED灯点亮。然后旋紧定位螺丝，直到LED灯熄灭，再额外旋紧1/4圈。
Kohler Co.
Open Position
开启位置
13
Closed Position
LED
关闭位置
LED灯
Setscrew
定位螺丝
1198298-2-C
Advertisement
Table of Contents
