Headphone Output; Headphone Volume Knob - Universal Audio Volt 1 Hardware Manual

Rotate this knob to adjust the volume of speakers connected to
the Monitor outputs. The output signal level meters indicate the
output levels.

(7) Headphone Output

Connect stereo headphones to this output. Headphones are
connected with a ¼" (6.35 mm) TRS plug. If your headphones
have a ⅛" (3.5 mm) plug, use a TRS ⅛" to ¼" adapter.

(8) Headphone Volume Knob

Adjust the headphone volume with this knob. The headphone
volume control is independent from the Monitor volume control.
Note: The monitor output and headphone signals are the same.
(9) Direct Monitoring Button
Press this button to enable or disable direct monitoring. Direct
monitoring is on when the button is lit blue, and off when the
button is unlit.
Important: Direct monitoring applies to the input signals only.
You always hear audio from your computer or audio software
regardless of this setting.
DIRECT MONITORING NOTES
When enabled, direct monitoring slightly reduces the
•
volume from your audio software so you can clearly hear
your input signals.
When direct monitoring is on, disable the software
•
monitoring feature in your audio software to prevent
signal doubling, which can make your input sound thin or
"phasey."
When direct monitoring is off, you may notice your inputs
•
have latency (a slight delay) before they are heard, as a
result of buffering and signal processing by the audio
software.
WHAT IS DIRECT MONITORING?