CORRECTIVE MAINTENANCE
VISIFILTER ELEMENT REPLACEMENT
Follow the procedure listed below to replace the VisiFilter element when it becomes clogged or discolored.
1. Disconnect the handpiece air hose by gently turning and
pulling the coupled Fittings.
2. Disconnect the Visifilter and hose assembly from the
Power Source by gently turning and pulling the male
Fitting inserted into the SNAP-VAC Port.
3. Disconnect VisiFilter from both attached 1 inch air hoses
by gently turning and pulling the VisiFilter while holding
each of the hoses.
4. Separate the 2 plastic housing halves of the VisiFilter in the
following manner.
a) Grasp the VisiFilter in the palm of the hand with the
Male Nib (air hose connection) marked "FLOW IN"
facing you.
b) Pull against one of the Wing Tabs while pulling on the
Male Nib with the free hand to open the
interconnection of the plastic housings at that Wing
Tab.
c) Pull against the second Wing Tab while pulling on the
Male Nib to open the remaining interconnection and
separate the plastic housings.
5. Remove the old or discolored Element and discard.
6. Insert the replacement VisiFilter Element into the housing
marked "FLOW IN". Center the Element in the housing
well.
7. Squeeze the 2 plastic housing halves together using 4 plastic
Bumps on the housing marked "FLOW OUT" as pressure
points. The 2 plastic housings will snap together and lock the
VisiFilter Element in position.
8. Reconnect the 1 inch air hoses (removed in step 3) to the
VisiFilter.
9. Attach VisiFilter and hose assembly to Power Source by
inserting male Fitting into the SNAP-VAC Port.
Figure 8. VisiFilter Element Replacement
REPAIR
21