Table of Contents
Advertisement
MICROCHINE
HANDPIECE
Nominal Output
Speed Range:
Output Torque:
Speed Regulation:
Duty Cycle:
Shaft Run-Out at Collet:
EOS/ESD
Tip-To-Ground
Resistance:
AC Leakage :
PULSE PLATE
Output Voltage Range:
PULSE HEAT
Output Voltage Range:
GENERAL INFORMATION
2,500 rpm, min. to 10,000 rpm, max.
14 N•mm (2.0 inch-ounces), min.
+10/-15% over Line/Load range of 0 to 14 N•mm (0 to 2 inch-ounces)
from low line to high line voltage.
Application Dependent. Continuous loading to maximum torque (Status
LED Amber in color) will cause the handpiece case to overheat.
Continuous heavy loading without a cooling period may cause damage
to the handpiece and/or the power source.
.13mm (0.005 inches) TIR (Total Indicator Reading) max.
Less than 5 ohms.
Less than 2 millivolts RMS from 50Hz to 500Hz, min.
0 - 10 volts unfiltered, full wave DC.
0 - 2.3 VAC RMS
3
Advertisement
Table of Contents
