Troubleshooting Guide - Metrologic Eclipse MS5100 Installation And User Manual

T
ROUBLESHOOTING
The following guide is for reference purposes
representative to preserve the limited warranty terms on page 31.
S
YMPTOMS
No LEDs, beep
or laser line
No LEDs, beep
3 beeps on
power up
Continuous razz
tone on power up
Razz tone at
power up
Unit scans,
Communicates
and beeps twice
The unit powers
up but does not
beep
G
UIDE
P C
OSSIBLE
No power is being supplied to
the scanner
No power is being supplied to
the scanner from host
Non-volatile RAM failure
RAM or ROM failure
VLD failure or a Scanner
flipper failure
Same Symbol timeout set too
short
Beeper disabled. No tone
selected
only. Contact a Metrologic
( )
AUSE S
S
OLUTION
Check transformer,
outlet and power strip.
Make sure the cable is
plugged into the
scanner.
Some host systems
cannot supply enough
current to power the
MS5145. Use the
proper power supply.
Contact a Metrologic
Representative, if the
unit will not hold the
programmed
configuration.
Contact a Metrologic
Representative.
Contact a Metrologic
Representative.
Adjust same symbol time
out for a longer time.
Enable beeper. Select
tone.
15