Visual - Metrologic VoyagerGS MS9590 Installation And User Manual

I
NDICATORS

Visual

The MS9590 has three LED indicators
(blue, white, and yellow) located on the
head of the scanner. When the scanner
is in operation, the flashing, or stationary
activity of the LEDs indicates the status
of the scanner and the current scan.
All LEDs are Off
The LEDs will not be illuminated if the scanner is not receiving power from the
host or transformer.
The scanner is in idle mode and CodeGate is enabled.
Steady Yellow
Indicates CodeGate mode is disabled.
Steady Blue
When the laser is active, the blue LED is illuminated. The blue LED will remain
illuminated until the laser is deactivated (default mode only).
Steady Blue and Single White Flash
When the scanner successfully reads a bar code, the white LED will flash and
the scanner will beep once.
After a successful scan, the scanner transmits the data to the host
device. Some communication modes require that the host inform the
scanner when data is ready to be received. If the host is not ready to
accept the information, the scanner's white LED will remain on until the
data can be transmitted.
Alternating Flashing of Blue and White
During Operation
This indicates the scanner is in configuration mode.
Figure 15. LED Configuration
17