Table of Contents
Advertisement
Maintenance
Maintenance
User maintenance is limited to cleaning the system and filter replacement. Only Stratasys
technicians are authorized to perform component testing and replacement.
Inspecting the System
If required by local laws and regulations, this system must be inspected.
Contact Stratasys for more information about inspection and certification.
Cleaning the System
•
The exterior of the system can be cleaned with a damp cloth and non-aggressive
detergent.
•
The cooling inlets and outlets should be cleaned once a year to prevent accumulation of
dust and thereby overheating of the system.
Replacing the Filters
The air extraction system contains a pre-filter pad and a combined filter. Replace the filters
regularly.
To maintain performance, it is important that the filters are replaced with identical replacement
filters. To re-order, refer to the filter number printed on the filter installed in your extraction
system.
Warning: Personal Injury Hazard
Unauthorized work or the use of unauthorized replacement filters may result in a
potentially dangerous situation and/or damage to the extraction system, and will void
the manufacturer's warranty.
Caution:
Do not use an abrasive cleaning product as this will damage the finish.
Caution:
To prevent overheating, do not use the system with a blocked filter, or with dust
obstruction of inlets/outlets.
It is recommended that a spare set of filters are kept on site to avoid prolonged
system unavailability. Part numbers for replacement filters can be found on the filters
fitted in your system.
© Copyright 2020 Stratasys. All rights reserved.
Inspecting the System
Page 9
Advertisement
Table of Contents
