Table of Contents
Advertisement
Installation
Installation
Connecting to the Power Supply
Follow the specifications listed in
supply outlet for the extraction system, and verify the power supply is suitable before
connecting the system.
The power outlet at the site should be located near the system. The power cable should be
routed so as not to create a trip hazard.
Connecting to the 3D Printer
1. Connect the control cable from the extraction system (shown in
AUX 24V connector in the connection panel on the back of the J55.
Warning: Electric Shock Hazard
The extraction system must be connected to a properly grounded outlet.
Important:
Check the integrity of the electrical power cable. If the power cable is damaged, do not
connect the extraction system to the main power supply. The power cable should only
be replaced by a Stratasys engineer, as an electrical safety test might be required after
replacement.
Figure 5: J55 exhaust vent and power connection panel
© Copyright 2020 Stratasys. All rights reserved.
"System Specifications" (page 12)
Exhaust duct
adapter
Control cable
connector
Connecting to the Power Supply
when selecting the power
Figure 3 (page
2)) to the
Page 7
Advertisement
Table of Contents
