Date; Ethernet Module; Gsm Module; Statistics - Tech Controllers EU-402N PWM User Manual

2.3.

DATE

This submenu enables the user to set current date. Time and date settings are essential for energy counting function to
operate correctly.
2.4.

ETHERNET MODULE

Internet module is a device enabling the user remote control of the solar heating system via the Internet at emodul.eu.
The user controls the status of all heating system devices on the home computer screen and the operation of each device
is presented in the form of animation. Apart from the possibility to view the temperature of every sensor, the user can
change the pre-set temperature of the tank etc. (depending on the type of installation scheme selected).
The installation process is intuitive. Connect the module and go to the main controller menu to activate the Internet
module (Menu>>Ethernet module>>ON). Once Registration option has been selected, the device generates a code which
must be entered on the website.
NOTE
This type of control is available only after purchasing and connecting an additional controlling module ST-505
which is not included in the standard controller set.
NOTE
The code is valid for 60 minutes. If the user fails to register on the website within this time, a new code must be
generated. Internet module parameters such as IP address, IP mask, gate address etc. may be set manually or by
selecting DHCP option.
2.5.

GSM MODULE

GSM Module is an optional device which, cooperating with the controller, enables the user remote control of the CH
boiler operation via mobile phone. The user is sent an SMS each time an alarm occurs. Moreover, after sending a certain
text message, the user receives feedback on the current temperature of all the sensors.
ST-65 module may operate independently of the collector controller. It has two additional inputs with temperature
sensors, one contact input to be used in any configuration (detecting closing/opening of contacts) and one controlled
output (e.g. a possibility of connecting an additional contractor to control any electric circuit)
When any of the temperature sensors reaches the pre-set maximum or minimum temperature, the module automatically
sends an SMS message with such information.A similar procedure is used in the case of opening or closing of the contact
input, which may be used as a simple means of property protection.
NOTE
This type of control is available only after purchasing and connecting an additional controlling module ST-65
which is not included in the standard controller set.
2.6.

STATISTICS

This submenu enables the user to monitor current operating status of the controller:
8