Baseus Encok W01 User Manual page 4

Single earphone pairing mode
Pick up a single earphone from the charging case, the earphone will be turned on
•
automatically with blue light flashing, the earphone will go into pairing mode.
Search for device named "Baseus Encok W01" on the mobile phone and click to
•
connect.
Note: If a single slave earphone is picked up from the charging case, the blue light
will flash alternately, and it will look for the master earphone. When the
earphone fails to find it, it will connect to the mobile phone alone. If the master
earphone is picked up from the charging case, it will connect directly to the
mobile phone.
TWS earphone Pairing mode
The earphone will be automatically powered on after removing both earphones
•
from the charging case at the same time. Master (L) and slave ® will enter pairing
mode with blue light flashing. After the two earphones are connected
successfully, the master (L) earphone will flash blue light quickly and slave (R)
flashes blue light every 5 s. Then the TWS earphone is entering TWS pairing
mode.
Search for device named "Baseus Encok W01" on the mobile phone and click to
•
connect.
Note:
While the two devices pair for the first time, please keep the wireless earphone
•
within 1 m from your mobile phone.
Turn on the wireless function on your mobile phone, search for the device and
•
select the correct device model: Baseus Encok W01, then click to connect.
Enter the pairing password "0000" (some mobile phones may need a password)
•
If pairing fails, please repeat it again till blue LED flashes slowly.
•
If the slave earphone and master earphones are not successfully paired, please
•
put both into the charging case and long press MFB for 10 s to clear the
earphone pairing information and then repeat the pairing steps.
4