Network Requirements - H3C S9500 Series Operation Manual

Operation Manual – POS Interface
H3C S9500 Series Routing Switches
Shut down the POS
interface
Note:
At present, POS interfaces on S9500 series routing switches only support PPP on
data link layer.
Currently, POS interfaces on S9500 series routing switches do not support IPv6
multicast. Therefore, the commands related to IPv6 multicast are not supported in
POS interface view.
On PPP links, as IPv6CP cannot obtain the peer IPv6 addresses through
negotiation, static routes or routing protocols are required to achieve hardware IPv6
forwarding on POS interfaces.
If a physical interface is idle or has no cable connection, shut down it with the
shutdown command to avoid interface anomalies that may result from interference.
As the shutdown command disables an interface, use the command with caution.
1.3 Displaying and Maintaining POS Interfaces
Display the information of a POS
interface
Display the IP-related
information of a POS interface
Display the IPv6-related
information of a POS interface
1.4 POS Interface Configuration Example

1.4.1 Network Requirements

Use a pair of optic fibers (respectively for receiving and sending data) to connect the
POS interfaces on Switch A and Switch B.
Encapsulate the interfaces with PPP.
To do...
shutdown
To do...
Chapter 1 POS Interface Configuration
Use the command...
Use the command...
display interface pos
[ interface-number ]
display ip interface pos
interface-number
display ipv6 interface pos
interface-number
1-3
Remarks
Optional
POS interfaces are
enabled by default.
Remarks
Available in any
view