Table of Contents
Advertisement
Toro TEMPUS-AG-MS
INTRODUCTION
TEMPUS-AG-MS is a battery powered Bluetooth® / LoRa
measurements from sensors of temperature, humidity, flow, wind speed. TEMPUS-AG-MS transmits data via LoRa
connection to aTEMPUS-AG-4G/WF gateway. TEMPUS-AG-MS available in two models: S4 with 4 inputs (3 sensor
inputs and 1 temperature input) and S1 with 1 input (1 sensor input).
SPECIFICATION
DIMENSIONS
Width: 10,5 cm
Height: 4,8 cm
Depth: 11,6 cm
FEATURES
Bluetooth® Smart 4.0 Low Energy
LoRa
radio communication
TM
Permament programming memory
USE
Polution level 2
Maximum relative humidity of 80% for
temperatures up to 31°C and linear decrease up
to 50% of relative humidity at 40°C
Indoor and outdoor use
Use in humid environment IP68
(test conditions: 1h at 1m depth)
Operating temperature: from -20°C to 50°C
Altitude use up to 2000m
Installing the wrong type of battery may cause an explosion or fire hazard.
INSTALLATION GUIDELINES
The TEMPUS-AG-MS is made for an outdoor use. You can place it in a buried valve box or set it on a wall
(concrete, brick, cinder blocks) with 2 dowels and 2 countersunk screws of 4X40 not included.
In order to clean the TEMPUS-AG-MS, use soapy water with a sponge and then a soft cloth to wipe it off.
2
, Multi Sensor device. This device allows the acquisition of
TM
POWER SUPPLY
9V 6AM6 ou 6LR61 Alkaline battery
Not included
Current consumption : 0.1mA
INSTALLATION
1 (S1) or 3 (S4) configurable inputs to choose from:
• Dry contact (rain sensor, wind sensor, ...)
• Pulse (flowmeter, wind sensor, ...)
• Analog (0-3.5V) (moisture sensor, tensiometer, ...)
1 (S4 only) temperature acquisition input (type Pt100)
3V5 supply sensor
The voltage value assigned to each mounted terminals is
3.3V (red wire to each inputs).
Note: the referrenced sensors in this user manual are the
ones recommended for the TEMPUS-AG-MS use.
Advertisement
Table of Contents
