Advertisement
INTRODUCTION
The TEMPUS-AG-PR is a sensor device powered by a 9V battery and used only for reading and controlling
the pressure of your irrigation system. Thanks to the prewired pressure sensor, the TEMPUS-AG-PR will put
the pressure under control and will alert if the tresholds are exceeded. The tresholds can be set from the
MyToroTempus application or platform. TEMPUS-AG-PR transmits data via LoRa connection to a TEMPUS-AG-4G/
WF gateway.
SPECIFICATION
DIMENSIONS
Width : 10,5 cm
Height : 4,8 cm
Depth : 11,6 cm
FEATURES
Bluetooth® Smart 4.0 Low Energy
LoRa
radio communication
TM
POWER SUPPLY
9V 6AM6 ou 6LR61 Alkaline battery
(not included)
Current consumption : 0.1mA
Sensor power supply : 5VDC (TBTS)
Installing the wrong type of battery may cause an explosion or fire hazard.
INSTALLATION GUIDELINES
The TEMPUS-AG-PR is made for an outdoor use. You can place it in a buried valve box or set it on a wall (concrete,
brick, cinder blocks) with 2 dowels and 2 countersunk screws of 4X40 not included.
In order to clean the TEMPUS-AG-PR, use soapy water with a sponge and then a soft cloth to wipe it off.
When replacing the sensor, only use a sensor with a waterproof connector (MIPAG1XX004BAAAX).
USE
Operating temperature : -20°C to 50°C
Indoor and outdoor use
Use in humid environment IP68
(test conditions: 1h at 1m depth)
Altitude use up to 2000m
Polution level 2
Maximum relative humidity of 80% for temperatures up to 31°C
and linear decrease up to 50% of relative humidity at 40°C.
INSTALLATION
1 (S1) Pressure Sensor
Pressure : 0 to 16 bars
Screw thread : G1/4 EN837
Toro TEMPUS-AG-PR
2
Advertisement
