Getting Started Using Your Dvd Player; Playing Dvds, Video Cds And Cds - Marantz DV-12S1 User Manual

Getting Started
Using Your DVD
Player
Playing DVDs, Video CDs and
CDs
– DVD/Video CD/CD
Before you can start to enjoy the digital audio and video on
DVDs, be sure that you have either performed the Setup
Navigator procedure described in the previous section or
made the necessary settings in the Setup screen menus as
outlined in the next section to set up the player to correspond
to your home system. Having made these settings, you are
now ready to start using the player to enjoy DVDs, Video
CDs, and CDs.
OPEN/CLOSE
2
DISPLAY F.MEMO
A-B REPEAT PROGRAM
ANGLE SUBTITLE
TOP MENU ENTER
RETURN
1 2
4 5
7 8
SEARCH 0
CLEAR LAST MEMO
RC-12DVS1
1 3
DVD PLAYER DV-12S1
VIDEO ON/OFF
DIMMER RANDOM
V-PART DVD 192kHz
POWER AUDIO 96kHz
GRP TRK DOLBY D
TITLE DIG OFF CHP TEMAIN
STANDBY
POWER
1
VIDEO ADJ.
AUDIO
MENU
5
SETUP
3
6
9
+10
4
CONDITION
MEMO
2 4
PLAY STOP PAUSE
OPEN/CLOSE
PROGRESSIVE LAST MEMO
CONDITION
TOTAL VIDEO OFF DOWN MIX
L C R
FL OFF
LFE
LS S RS
1
Press Power button on the front panel.
• Press the POWER button on the Front panel to turn
the power on, and press it again to turn the power off.
Note
When it is required to remote control the power mode of this DVD
player, be sure to leave this switch in the power on mode.
2
Press OPEN/CLOSE.
The disc tray comes out.
3
Load a disc.
• Load a disc with the label side facing up, using the
disc tray guide to align the disc.
4
Press PLAY 3 3 3 3 3 .
• The disc tray closes, and playback begins.
• Depending on the disc, a menu may be displayed.
If a menu is displayed, proceed to step 5.
5
Select the item you want to view.
• When a DVD is loaded:
Select the item with the cursor control joystick or the
number buttons then press ENTER.
• When a Video CD is loaded:
Use the number buttons to select the item.
Notes
• Noise is output if you make digital audio connections to a
receiver or amplifier that does not have a built-in decoder. Check
that the digital audio output format selected in the
Audio 1 menu corresponds to the audio components you have
made connections to (pages 31-32).
• The TV screen size is factory set to present the wide screen
format (16:9 aspect ratio). If you have a standard TV screen (4:3
aspect ratio), this setting can be changed to match your TV
screen size in the Video menu (page 36).
When an operation is prohibited
There are times when you are using the player and attempt to
perform an operation, but for some reason it cannot be
performed. When this occurs, one of the two following icons
appears on the screen.
The operation is prohibited by the player.
The operation is prohibited by the programming on
the disc.
ENGLISH
25