Britax ONE4LIFE CLICKTIGHT User Manual page 19

1� Refer to page 37 to
convert from harness to
BOOSTER mode.
2� Adjust the child restraint to
position "B" by pushing the
red recline button on either
side of the base.
3� Extend the top tether strap
by lifting on the top tether
adjuster.
4� Unhook the top tether
hook from the back of child
restraint and place it up and
over the seatback.
5� Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
6� For models WITH storage
pouch only: Open the
storage pouch.
Remove the lower
connectors by pressing
the spring tab, pushing
the connector back while
rotating down and forward
off the anchor point.
7� Extend lower connector
strap to its longest length
by pressing the grey button
on adjuster.
32
Table of Contents
B
B
Without
With storage
storage pouch
pouch
(Select Models)
8� Place child restraint on
the vehicle seat so that the
car seat base is flat on the
vehicle seat and is parallel to
vehicle seat.
NOTE: If your vehicle seat
back is adjustable, ensure
it is in the upright position
before placing the child seat
on the vehicle seat.
9� Ensure the base does not
hang over front edge of
vehicle seat.
10� Route the lower connector
strap through the
FORWARD-facing belt
path marked by green
labels. Firmly press the
lower connectors onto their
adjacent lower anchors.
11� Ensure the connector strap
is not twisted and remove
slack.
12� Close the CLICKTIGHT over
the lower connector strap.
13� Ensure both CLICKTIGHT
release buttons are visible.
NOTE: If it is difficult to close,
you may have removed too
much slack.
14� Connect the top tether hook
to the vehicle's top tether
anchor (check the vehicle
owner's manual for location).
15� Pull the top tether strap to
remove slack and secure
excess webbing with the
elastic band attached.
Table of Contents
ADJUSTMENT
SLOT
CLICK
33