Installation With Lower Anchor Connectors And Top Tether (Latch) �27 - Britax ONE4LIFE CLICKTIGHT User Manual

11� Ensure both CLICKTIGHT
release buttons are
visible.
NOTE: If it is difficult to
close, you may have locked
your vehicle seat belt or
removed too much slack.
12� Connect the top tether
hook to the vehicle's top
tether anchor (check the
vehicle owner's manual
for location).
13� Pull the loose tether
strap end to remove
slack and secure excess
webbing with the elastic
band attached.
9 Both red CLICKTIGHT release buttons are visible after
installation.
9 All connections are secure and vehicle belt is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be
parallel to vehicle seat.
9 Recline indicator is still within the correct section for
FORWARD-facing, after child is secured.
9 Child restraint cannot be moved front to back or side to
side more than 1 in. (2.5 cm) at the belt path.
9 Both vehicle lap and shoulder belts are routed through the
CLICKTIGHT.
9 Excess top tether webbing is contained within your vehicle
and secured.
9 The anti-rebound bar MUST be removed.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
26
Table of Contents
Installation with Lower Anchor Connectors and Top Tether (LATCH)
Do not install by this method for a child weighing more than
30 pounds (13.5 kilograms).
1� Extend the top tether strap
by lifting on the top tether
adjuster.
2� Unhook the top tether hook
from the back of the child
restraint and place it up and
over the seatback.
3� Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
4� For models WITH storage
pouch only: Open the
storage pouch.
Remove the lower
connectors by pressing
the spring tab, pushing
the connector back while
rotating down and forward
off the anchor point.
5� Extend lower connector
strap to its longest length
by pressing grey button on
adjuster.
6� Recline child restraint to the
appropriate position. Refer
to page 15 to determine
appropriate recline position.
7� Place child restraint
FORWARD-facing on the
vehicle seat so that the
car seat base is flat on the
vehicle seat and is parallel to
vehicle seat.
8� Ensure that no more than
3 in. (7.5 cm) of the base
hangs over the front edge
of the vehicle seat.
Table of Contents
Without
With storage
storage pouch
pouch
(Select Models)
3 in
27