Troubleshooting - Atwood SCALE-O-MATIC Operation And Safety Manual

Multi dough divider

Hide thumbs

Table Of Contents

Table of Contents

A.M. MFG. CO.

DIV. OF ATWOOD CORP.

DANGER

ALWAYS DISCONNECT ELECTRICAL POWER SOURCE

WHEN MAINTAINING OR REPAIRING THIS MACHINE...

THE OPERATION OF THE SCALE - O - MATIC DEPENDS ON VACUUM, FOR TOP

PERFORMANCE. THIS CAN ONLY BE REALIZED IF ALL SEAL POINTS ARE IN PROPER

ADJUSTMENT. THE FOLLOWING PLACES FOR POSSIBLE LOSS OF VACUUM ARE TO BE

CHECKED:

1. PART NO.

S0113CD

GEAR

MAKE SURE MACHINE IS RUNNING IN THE RIGHT DIRECTION. SEE ARROW ON GEAR.

GEAR MUST TURN CLOCKWISE.

2. PART NO. 402CD-NEOPRENE "O" RING

CHECK FOR WEAR AND LOSS OF RESILIENCY.

3. PART NO. 506MS-SLIDE PRESSURE STRIPS-POLYETHYLENE

CHECK FOR LOSS OF COMPRESSIBILITY.

4. PART NO. 521MS SLIDE WEAR STRIP-NYLON

CHECK FOR WEAR.

5. PART NO. 504MS GIB SCREWS

CHECK FOR SNUGNESS

6. PART NO.

323PY

PISTON RING

CHECK FOR WEAR-REPLACE IF WORN OR SCORED.

7. PART NO.

503MS

MEASURING CUP PLUNGER ROD GUIDE

CHECK FOR WEAR AND SMOOTHNESS OF OPERATION. IF WORN PART NO. 513MS WILL

BIND OR STICK.

8. PART NO. 513MS PLUNGER

CHECK FOR CIRCUMFERENCE WEAR, REPLACE IF DOUGHS BY-PASS INTO SPRING

SECTION.

9. PART NO. 434CD V-BELT DRIVE

KEEP BELT TIGHT TO AVOID SLIPPAGE.

10. PART NO.

401CD

SEAL SCRAPER RING

CHECK FOR WEAR AND FOR STRAIGHTNESS.

11. PART NO.

S0113CD

GEAR

CLEAN CAM TRACK OCCASIONALLY. OBSERVE IF PART NO.

IS WORN, ALSO CHECK FOR WEAR ON GEAR CAM TRACK.

12. PART NO. S507MS/B BRONZE GIB BAR

CHECK GIB BARS FOR WEAR AND EXCESSIVE PLAY BETWEEN DIVIDER SLIDE.

13. PART NO. 704OS

CHECK TO SEE IF CLOGGED WITH DOUGH.

ARE NON-CURRENT PARTS (OBSOLETE)

(SEE DETAIL "A")

GREASE ALL FITTINGS REGULARLY

* *

S500_31.DOC

MASTER