Table of Contents
Advertisement
A.M. MFG. CO.
DIV. OF ATWOOD CORP.
© 1996
DANGER:
ALWAYS DISCONNECT ELECTRICAL POWER SOURCE WHEN
CLEANING, MAINTAINING OR REPAIRING THIS MACHINE...
LOWER LARGE CONVEYOR BEFORE MOVING OR
RELOCATING MACHINE...
STEP 1
RAISE PRESSURE PLATE ASSEMBLY (1), SLIDE PRESSURE
PLATE (2) TOWARDS UNIT UNTIL DISENGAGED FROM THE
PRESSURE PLATE MOUNTING RODS (3).
CAUTION:
THIS STEP MUST BE PERFORMED FIRST TO PREVENT
PRESSURE PLATE FROM SLIPPING OFF.
STEP 2
SLIDE MOUNTING FRAME (4) TOWARDS UNIT UNTIL
DISENGAGED FROM SPACER (5). PIVOT MOUNTING FRAME
(4) UP UNTIL IT RESTS IN CLEANING POSITION. CLEAN
GUIDES (6) AND CUTTER ASSEMBLY (7).
STEP 3
CLEAN PRESSURE PLATE (2).
STEP 4
REMOVE EXCESS DOUGH FROM BELT.
S500_11.DOC
MASTER
GUIDE TO CLEANING
11
STEP 5
SET PRESSURE (2) IN POSITION ON BELT.
STEP 6
PIVOT MOUNTING FRAME (4) DOWN, CAREFULLY ALIGNING
PRESSURE PLATE (2) INTO POSITION BETWEEN GUIDES.
STEP 7
POSITION PRESSURE PLATE (2) ONTO PRESSURE PLATE
MOUNTING RODS (3).
STEP 8
SLIDE MOUNTING FRAME (4) BACK ONTO SPACERS (5).
STEP 9
REMOVE CRUMB TRAY (8) BY SLIDING IT OUT FROM UNDER
CONVEYOR.
STEP 10
TO CLEAN THE SCRAPER BLADE (9), LOCATE BLADE
UNDERNEATH THE CONVEYOR AND REMOVE EXCESS
DOUGH
MODEL:
S500
1/96
Advertisement
Table of Contents
