Guide To Cleaning - Atwood SCALE-O-MATIC Operation And Safety Manual

A.M. MFG. CO.
DIV. OF ATWOOD CORP.
© 1996
DANGER:
FIGURE 1
STEP 1
USING AN ALLEN WRENCH, LOOSEN SOCKET
HEAD SCREWS (2) AND LIFT OFF DIVIDER
PLUNGER (MEASURING CUP) (3). WHEN A #2
OR #3 MEASURING CUP IS USED ON DIVIDER,
THE DIVIDER CYLINDER MUST ALSO BE
REMOVED FROM SLIDE FOR CLEANING.
STEP 2
LOOSEN EIGHT HEX HEAD BOLTS AT TOP OF
GIB BARS. USING WRENCH (1) REMOVE TWO
HEX HEAD SCREWS (4) AND PUSH DIVIDER
SLIDE (5) REARWARD TO EXPOSE CYLINDER
OPENING.
STEP 3
REMOVE CABINET DOOR (6).
STEP 4
WITH CYLINDER OPENING EXPOSED,
REMOVE SEAL SCRAPER RING (7) AND
RUBBER "O" RING (8). CLEAN ALL EXPOSED
SURFACES INCLUDING "O" RING GROOVE
AND DIVIDING SLIDE OF ACCUMULATED
DOUGH, OIL, ETC. WIPE EXCESS DOUGH
FROM TOP AND INTERIOR OF CYLINDER.
S500_9.DOC
MASTER

GUIDE TO CLEANING

ALWAYS DISCONNECT ELECTRICAL POWER SOURCE WHEN
CLEANING, MAINTAINING OR REPAIRING THIS MACHINE.
SCALE - O - MATIC NAME PLATE
THIS PLATE HAS A 2-CHANNEL GROOVE THAT
CATCHES EXCESS OIL AND DRAINS INTO DRIP
PAN AT THE BOTTOM OF THE MACHINE. THIS
PLATE SHOULD BE REMOVED BY LOOSENING AND
REMOVING A SMALL ALLEN SCREW IN THE
CENTER OF THE PLATE. CLEAN PLATE, AND
CHECK PLASTIC DRAIN LINE TO SEE THAT IT IS
CLEAN AND FREE OF ANY SEDIMENT SO OIL CAN
DRAIN PROPERLY. DRIP PAN AT BOTTOM OF
MACHINE SHOULD BE EMPTIED EVERY DAY.
9
MODEL:
S500
FIGURE 2
1/96