Table of Contents
Advertisement
General Information
• Observe the safety information
• Only qualified and authorised persons may carry out
repair work.
• In case of faults, the operating and maintenance instruc-
tions must be referred to for correct operation and main-
tenance.
Fault Table
Possible cause
Engine does not start
Speed control lever in «STOP»-position
No fuel reaching injection pump
– Tank run dry
– Fuel filter blocked
– Defective feed pump
Oil pressure lost
Compression too low
Engine stops by itself during regular operation
Fuel supply is interrupted
– Tank run dry
– Fuel filter blocked
– Defective feed pump
Oil pressure lost
Mechanical defects
Reduced engine performance
Fuel supply is obstructed
– Tank run dry
– Fuel filter blocked
– Tank venting is inadequate
– Leaks at pipes unions
Air cleaner blocked
Incorrect valve clearance
Too much oil in engine
Too much oil in exciter
Default in hydraulic system
Engine runs, machine does not move forward
Centrifugal clutch lining worn
Too much oil in exciter
Default in hydraulic system
TROUBLESHOOTING
• If the cause of the fault cannot be located or remedied, an
authorised Stanley Service Center should be contacted.
• Always first check the most likely causes (fuses,
LEDs, etc.).
Remedy
Set lever to «START»-position
Add fuel
Renew fuel filter
Function must be checked
Check engine oil level
Contact a HATZ-service center
Add fuel
Renew fuel filter
Function must be checked
Check engine oil level
Contact a HATZ-service center
Add fuel
Renew fuel filter
Ensure that tank is adequately vented
Check threaded pipe unions
Remove dirt from air cleaner
Adjust valve clearance
Correct the engine oil level
Check exciter oil level
Contact a Stanley-service center
Replace linings and springs
Check exciter oil level
Contact a Stanley-service center
Remarks
Activate mechanical oil pressure
monitor
Activate mechanical oil pressure
monitor
Contact a Stanley-service center
Contact a Stanley-service center
SRP 6570 User Manual ◄ 23
Advertisement
Table of Contents
