Overview; Introduction; Unpacking; Construction Of The Ph Detector For Pure Water Measurement - horiba HP-8A Instruction Manual

Overview

Introduction

This product is a detector for measuring of low conductivity sample. Measuring pH of low
conductivity sample is quite difficult for the ordinary pH meter. It is necessary to reduce the
impedance of the liquid by the neutral solution. The inner solution of the reference electrode
leaks much more than the ordinary pH reference electrode and reduces the impedance of the
sample.
This product can connect to a pH transmitters of on-site industry type or a panel-mount type
pH meters. Refer to the instruction manuals for the key operation or setting of each
transmitter.

Unpacking

Upon delivery of this product, unpack the packing immediately and check the contents of the
packing for incompleteness. In addition, check this product for any damage at the same time.
If you found any failure consult a distributor.
 Construction of the pH detector for pure water measurement
pH detector

pH flow cell

 Breakdown of complete set (standard)
pH detector for pure water measurement......
Accessories
O-ring (P6)..............................................

O-ring (P8)..............................................

O-ring (P22)............................................

O-ring (P45)............................................

Ceramic junction.....................................

Skirt HP...................................................

3.33 mol/L KCl solution...........................

pH electrode............................................

KCl tank...................................................

Tank bracket............................................

Nipple (12 mm)......................................

Instructions manual.................................

1 set
2
2
2
1
1
2
250 mL  2
1
1
1
2
1
Overview
1