Download Print this page

Toshiba RBC-U33P-E Installation Manual page 6

Ceiling panel

Advertisement

Installation of air inlet grille
• Install the air inlet grille in the reverse procedure of the removal.
• Be sure not to pinch the louver motor wiring to install the air inlet grille.
• Attach a Safety strap hook of the air inlet grille to the ceiling panel.
REQUIREMENT
• Use the wired remote controller to change the setting.
• The setting cannot be changed using the wireless remote controller, sub remote controller, or remote-controller-less system
(for central remote controller only). Therefore, installs the wired remote controller to change the settings.
CAUTION
Set only the CODE No. shown in the following table: DO NOT set any other CODE No.
If a CODE No. not listed is set, it may not be possible to operate the air conditioner or other trouble with the product may
result.
1. Turn the power on.
2. Push and hold
+
+
Confirm that CODE No. is [10]. Also, the fan of the selected unit runs and the louvers start swing.
• If the CODE No. is not [10], push
3. Select an indoor unit to be set by pushing
button is pushed.
4. Change the CODE No. to [47] with
5. Set the (SET DATA) like as the following table with
6. Push
button. The display state changes from flashing to lighting, and the setting is fixed.
7. Continue set the CODE No. [48] ~ [4E] like as the table with repeat procedure (4) - (6).
• To change setting of another indoor unit, repeat from procedure (3)
8. When settings have been complete, push
• When
button is pushed,
normal stop mode. (While
CODE No.
47
48
49
4A
4B
4C
4D
4E
3. Louver operation set up
buttons simultaneously for 4 seconds or more. After a while the display flashes.
button to clear the display content, and repeat the procedure from the beginning
button (Left side of the button). Indoor unit No. changes each time the
buttons.
TIME
button to determine the settings.
flashes and then the display content disappears and the air conditioner enters the
is flashing, no operation of the remote controller is accepted.)
SET DATA
0024
0024
0030
0035
0040
0043
0046
0060
Safety strap hook
buttons.
<RBC-AMT32E>
4 8 6 2
- 6 -
Hook hole of
ceiling panel
5 3

Advertisement

loading