Advertisement
Installation of adjust corner cap / air inlet grille
• This ceiling panel can be installed from anyway of 4 directions by turning the air inlet grille. Change the direction as shown
in figure on the customer's demand for a company name on the corner cap or according to the direction matching of the air
inlet grille when multiple units are installed.
• Be sure to install the Wireless remote controller kit (separate sold parts) or the Occupancy sensor (separate sold parts) in
correct orientation, since the Wireless remote controller kit or Occupancy sensor can be installed at only one diagonal corner
of the drain pipe. Failure to do so cause the malfunction.
refrigerant pipe side
Position of hook for air inlet grill
at factory default.
drain pipe side
Installation of adjust corner cap
Push claw A (two positions) and claw B (three positions) into the holes, check that none of the claws are out of alignment.
Failure to securely fi t those claws into the holes cause water leakage
1. Hook the fall-preventive strap for adjust corner cap on the ceiling panel claw securely.
Claw (Hook here)
2. Insert two claws A on the adjust corner cap into the square holes of the ceiling panel in the arrow direction.
Square hole
Claw A
3. Align the three claws B on the back of the adjust corner cap with the holes on the corners of the panel and push them into
the holes.
Claw B
Push the three claws
into the holes.
Mounting position for adjust corner cap with company
name at factory default.
(The corner cap can be installed at any position when
not using the Wireless remote controller kit or the
Occupancy sensor.)
Indoor unit
Indoor unit
Fall-preventive strap
Adjust corner cap
Claw A
The Wireless remote
controller kit or the
Occupancy sensor
(separate sold parts)
• Only this position can
be installed.
Electrical control box
- 5 -
4 direction-free
Advertisement
