Table of Contents
Advertisement
6. Changing the feet
Should you wish to install your Health Care refrigerator,
you will not need the 40-mm feet. After having removed
the 40-mm feet, you can then re-attach the 12-mm
feet, located inside the 40-mm feet, to the front and
rear fixing points. The 40-mm feet and the 4 remaining
screws should be retained for future use.
7. Thermometer (Fig. 5)
Refer to the separate instruction leaflet supplied with
the thermometer. The thermometer can be stood up
using the attached stand or alternatively it can be fixed
to the refrigerator door, in which case the sensor wire
should be arranged so that it is not stretched or
damaged when the door is opened.
The temperature sensor is located inside the
refrigerator below the bottom shelf.
The display will then show the current, maximum and
minimum temperature
inside the refrigerator.
After the first pull down of the refrigerator (allow four
hours) please make a "reset" on the thermometer
because otherwise it will keep as "maximum" the
ambient temperature.
It is important to re-set the thermometer regularly to
ensure that the temperature is maintained between
2°C and 8°C.
The temperature readings may rise temporarily after
opening the door or placing additional items inside the
cabinet.
If applicable the battery transit strip must be removed
to activate the temperature display.
8. Useful suggestion
Do not overfill the appliance. It is advisable to leave
some space between the products in the cabinet to
ensure efficient and even cooling. If the shelves are
packed too tightly there may be unacceptable
temperature variations.
9. Defrosting, cleaning and
maintenance
Frost will gradually form on the cooling surfaces and it
must not be allowed to become too thick since it acts
as an insulator and interferes with the cooling.
To defrost, disconnect the refrigerator from the
electricity supply and leave the cabinet door open.
The frost will melt and the defrost water will run
through the drain tube from the drip channel into an
evaporating vessel located at the bottom rear of the
refrigerator. (Fig. 6) The defrost water will evaporate
automatically into the circulating air and the vessel will
not need emptying manually.
Figure 5.
Figure 6.
7
Advertisement
Table of Contents
