Establish Wireless Connection - LAUNCH TECH X-PROG3 Manual

LAUNCH
Engine/
Gearbox
programming
Power cable
Engine/
Gearbox
programming
MCU cable with
mutiple leads
Engine/
Gearbox
programming
Main diagnostic cable
• 3.1.2 Establish Wireless Connection
You must make sure that your diagnostic tool is well connected with
X-PROG3, follow steps below to check wireless connection:
Note: It is strongly recommended to connect the diagnostic tool with
the VCI connector using a USB cable for effective data transmission.
1. Slide down the status bar from the top.
2. Touch , go to Wireless and network->Bluetooth.
3. Select the X-PROG3 to be connected, wait until the connection is
successful.
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu
Connect power
N/A
supply
Connect
with the
engine
Connect with
or gear
3
X-PROG
box to be
repaired/
replaced
Connect with
Connect
Launch VCI
power
connector
supply
for data
cable
transmission
X-PROG3
Connect
with end B
the main
diagnostic
cable
N/A
Connect with
3
X-PROG
5