LAUNCH TECH X-PROG3 Manual page 3

LAUNCH
replaced with an incorrect type.
• Do not disconnect power abruptly when the test equipment is being
formatted or in process of uploading or downloading. Or else it may result
in program error.
• Do not delete unknown files or change the name of files or directories that
were not created by you, otherwise the test equipment software might fail
to work.
• Be aware that accessing network resources can leave the test equipment
vulnerable to computer viruses, hackers, spyware, and other malicious
activities that might damage your device, software or data. Ensure that you
have adequate protection in the forms of firewalls, anti-virus software, and
anti-spyware software and keep such software up to date.
• Do not disconnect battery or any wiring cables in the vehicle when the
ignition switch is on, as this could avoid damage to the sensors or the ECU.
• Do not place any magnetic objects near the ECU. Disconnect the power
supply to the ECU before performing any welding operations on the vehicle.
• Use extreme caution when performing any operations near the ECU or
sensors. Ground yourself when you disassemble PROM, otherwise ECU
and sensors can be damaged by static electricity.
• When reconnecting the ECU harness connector, be sure it is attached
firmly, otherwise electronic elements, such as ICs inside the ECU, can be
damaged.
Packing List
• Main unit
• Power adapter with power cable
• Main diagnostic cable
• MCU cable with multiple leads
• SOP8 chip converter
• EEPROM PCBA
• MCU PCBA V1
• MCU PCBA V2
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu
X-PROG3
III