Turn On The Module; Communication Via Usb Interface - Quectel RMU500-EKNM User Manual

Then, the assembly is finished. The assembled EVB kit is shown below.

4.2. Turn on the Module

1. Finish the assembling steps above.
2. Insert a (U)SIM card into the (U)SIM card connector on the EVB.
3. Insert the USB cable (Type-C to dual Type-A). Connect the type-C end to the EVB, one Type-A end
to the computer, and the other Type-A end to an auxiliary power supply. The module will be turned on
automatically when the EVB is powered through the USB interface (J301) or the power jack (J101).

4.3. Communication Via USB Interface

1. Power on the module according to the procedure in Chapter 4.1.
2. When the EVB is connected to a PC with the USB Type-C cable through the USB interface, run the
USB driver disk on the PC to install the USB driver. For details about USB driver installation, see
document [1]. The USB port numbers can be viewed in Device Manager of the PC when the USB
driver is installed, as shown below.
RMU500-EKNM_EVB_Kit_User_Guide
Figure 23: Assembled EVB Kit
5G Module Series
26 / 30