Table of Contents
Advertisement
Installation Procedures
Step 1:
The radio chassis is designed to be "Sleeve
Mounted" through a opening in the dashboard panel.
The required opening size is 182mm (7-3/16") x
52mm (2-1/16"). Cut or enlarged an opening in the
dashboard to accommodate the mounting sleeve.
Step 2:
If you are replacing an existing factory
installed radio, an adapter harness might be avail-
able for your vehicle to eliminate the need for
cutting your factory wiring. Contact Radio Shack
or other car stereo installation centers for the avail-
ability of a harness for your vehicle.
Step 3:
Insert the mounting sleeve into the hole in
the dashboard. Bend the metal tabs on the sleeve to
secure the mounting sleeve to the dashboard.
Step 4
: Bring all wiring for the connection of the
unit (including the antenna) through the center of the
mounting sleeve. Connect the wiring as follows:
Yellow Wire: Connect this wire to a constant +12
volt power source (a power source that is not con-
trolled by the ignition key).
Red Wire (with Fuse): Connect this wire to a
switched +12 volt power source (a power source
turned on and off by the ignition key).
Blue Wire: Connect this wire to the (+) power
antenna activation circuit or remote amplifier acti-
vation. If no power antenna or amplifier exists,
tape-off the end of this wire to prevent shorting
out the unit.
Black Wire: Connect this wire to the frame of the
vehicle (ground). This wire is the chassis grounding
wire for the unit.
White Wire: Connect this wire to the Left Front
Speaker (+) positive terminal or wire.
White Wire with Black Stripe: Connect this wire to the
Left Front Speaker (-) negative terminal or wire.
Green Wire with Black Stripe: Connect this wire to the
Left Rear Speaker (-) negative terminal or wire.
Green Wire: Connect this wire to the Left Rear
Speaker (+) positive terminal or wire.
Gray Wire: Connect this wire to the Right Front
Speaker (+) positive terminal or wire.
Gray Wire with Black Stripe: Connect this wire to the
Right Front Speaker (-) negative terminal or wire.
Purple Wire with Black Stripe: Connect this wire to
the Right Rear Speaker (-) negative terminal or wire.
Purple Wire: Connect this wire to the Right Rear
Speaker (+) positive terminal or wire.
8
Brown Cable with Red/White RCA Connectors:
Provides Left and Right Channel audio signal output
for input to an additional amplifier.
Black Cable with Blue RCA Connector: Provides
Sub Woofer audio signal output for input to an
additional amplifier.
Note 1: This unit is designed to connect to (4) four
speakers. If the installation only requires (2) two
speakers, use the White and Gray wire sets to con-
nect the speakers.
Note 2: If installation angle exceeds 30 degrees
from horizontal, the unit might not give its optimum
performance.
Note 3: Avoid installing the unit where it would be
subject to high temperature, such as from direct
sunlight, or from hot air, from the heater, or where is
would be subject to dust, dirt or excessive vibration.
Remove Transportation Screws: Before installing
the unit, please remove the two screws shown in
the illustration below.
Remove Transportation
Screws Before
Installation
WARNING!
Any wires left unconnected must be taped-off
or capped-off to prevent shorting.
DO NOT connect speaker ground wires together.
DO NOT connect speaker ground wires to the
chassis of the vehicle.
DO NOT connect front and rear speaker wires
together.
FAILURE TO FOLLOW ANY OF THESE
WARNINGS WILL RESULT IN DAMAGE TO
THIS UNIT AND VOIDS THE WARRANTY.
Advertisement
Table of Contents
