Securing The Rotor - Siemens SIMOTICS XP Operating Instructions Manual

Preparations for use
4.5 Transport and storage
Open bearings
• For open bearings, e.g. 1Z, check the status of the grease when stored for longer than 12
months.
• Replace the grease if it is identified that the grease has lost its lubricating properties or is
polluted. The consistency of the grease will change if condensation is allowed to enter.
Closed bearings
• For closed bearings, replace the DE and NDE bearings after a storage time of 48 months.
NOTICE
Storage
The motor can be damaged if you use it or store it unprotected outdoors.
• Protect the motor against intensive solar radiation, rain, snow, ice and dust. Use a
• If required, contact the service center, or technically coordinate outdoors use.
4.5.2

Securing the rotor

Depending on the version, the machine is fitted with a rotor shipping brace. This protects the
bearings against damage due to shock and vibration during transport or storage.
NOTICE
Motor damage due to vibrations
Not using the rotor shipping brace can cause damage to the machine if it is jolted during
transport or storage. Material damage can result.
• If the machine is fitted with a rotor shipping brace, this should always be used when
• Protect the motor against strong radial shocks and vibration when storing, as the rotor
• Do not remove the rotor shipping brace until you are ready to push on the output
• If the customer already has mounted parts, such as a coupling or belt pulley, the
• For machines with a vertical type of construction:
38
superstructure or additional cover, for example.
transporting the machine. The rotor shipping brace must be attached during the
transport.
shipping brace cannot completely absorb these forces.
element.
bearings can be damaged during transport. In this case, make sure that the customer
uses a rotor shipping brace.
– Do not remove the rotor shipping brace until the machine is in a vertical position.
– If a machine has to be transported in a horizontal position, the rotor must be fixed in
position before the machine is turned onto its side. Vertical machines can be supplied
in the horizontal position from the manufacturing plant.
1MB..5/6 shaft height 71 ... 355
Operating Instructions, 10/2021, A5E41926185A