Decommissioning The Machine; Re-Commissioning The Machine; Faults; Inspections In The Event Of Faults - Siemens SIMOTICS XP Operating Instructions Manual

8.5.2

Decommissioning the machine

• Record the decommissioning steps. This log will be useful upon recommissioning.
• If the machine is going to be out of service for longer than six months, then take the
necessary measures for preservation and storage. Otherwise, the machine could be
damaged as a result of not being operated.
8.5.3

Re-commissioning the machine

When you re-commission the machine, proceed as follows:
• Study the record made when the machine was decommissioned, and reverse the
measures that were taken for conservation and storage.
• Perform the measures listed in Chapter "Commissioning (Page 83)".
8.6

faults

8.6.1

Inspections in the event of faults

Natural disasters or unusual operating conditions, such as overloading or short circuit, are
faults that overload the machine electrically or mechanically.
Immediately perform an inspection after such faults.
Correct the cause of the fault as described in the respective remedial measures section.
Repair any damage to the machine.
8.6.2

Electrical faults

Note
If you are operating the motor with a converter, the operating instructions of the converter
must also be observed if electrical faults occur.
1MB..5/6 shaft height 71 ... 355
Operating Instructions, 10/2021, A5E41926185A
Operation
8.6 faults
99